This tent should be erected by at least two people! 1. When unpacking the tent, it is a good idea to familiarise yourself with how it should be repacked. 2. Spread out the flysheet on an area that is as even and clean as possible. 3. Assemble the fibreglass poles and push them through the sleeves marked with colour. The tent can now be raised by placing the ends of the poles down over the pins fastened in the rings. Then fasten the hooks on the flysheet to the poles. 4. Attach the front eyebrowpole, by pushing it through the sleeve and inserting the pole ends in the plastic sockets. 5. Position the tent as required. Peg it down through the loops and metal rings. Start at the ends and then do it all around. Use a mallet to secure the pegs in the ground but be careful of your hands and feet when hitting the peg. 6. The sleeping cabin can now be hung in the tent, using the straps with rings provided for the purpose and then attach the cabin to the floor with the hooks 7. Secure the tent against strong winds with guylines and pegs. 8. To adjust air flow with fully open rear ventilation, loosen the guylines attached to the rear ventilation cover, detach the toggle pins and reattach them to the toggle loops under the rear ventilation. Now roll up and toggle in the cover and enjoy the enhanced airflow inside the tent. Easy Camp products are made for camping use which is normally 2-5 weeks usage a year. They are not designed for permanent usage. Camping near the sea or lake can further enhance the effect of UV radiation. The same applies to poles and metal parts.